Connecting The Patient Circuit And Sensor Line; Turning The Mixer On - O-Two eAdvantage User Manual

4.2.4. Connecting the patient circuit and Sensor line

Connect a new patient circuit (01CV8037) to the 22mm outlet connection port,
remove the monitoring line plug, if applicable, and connect to the monitoring line
connection port (Fig. 2).
Note: Ensure both the monitoring line, and patient circuit are securely
connected.
The use of patient circuits, other than those approved by the manufacturer, may
interfere with the correct operation of this device. Therefore, the use of non-
approved circuits with this device will void the product warranty.
NEVER obstruct the output port or the scavenging connector outlet.

4.2.5. Turning the Mixer ON

To turn the mixer ON, depress the ON/OFF Control Knob
for 1 second.
eAdvantage User Manual
Remove the plug, if applicable, and connect to
the monitoring line connection port.
Fig. 2
WARNING
WARNING
13