Security; Troubleshooting Tips; Exterior Lights; Headlight Switch - RAM 1500 2025 Owner's Manual

50 GETTING TO KNOW YOUR VEHICLE
may take up to 30 seconds or longer in rare cases.
The garage door may open and close while you are
programming.
5. Push and hold the programmed HomeLink®
button and observe the indicator light.
NOTE:
●
If the indicator light stays on constantly,
programming is complete and the garage door/
device should activate when the HomeLink®
button is pushed.
●
To program the two remaining HomeLink®
buttons, repeat each step for each remaining
button. DO NOT erase the channels.
If you unplugged the garage door opener/device for
programming, plug it back in at this time.
Reprogramming A Single HomeLink® Button
(Canadian/Gate Operator)
To reprogram a channel that has been previously
trained, follow these steps:
1. Place the ignition in the ON/RUN position.
2. Press and hold the desired HomeLink® button
until the indicator light begins to flash after 20
seconds. Do not release the button.
3. Without releasing the button, proceed with
"Canadian/Gate Operator Programming" Step 2
and follow all remaining steps.
S
ECURITY
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, push and hold the two outside buttons for
20 seconds until the indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.
The HomeLink® universal transmitter is disabled when
the Vehicle Security system is active.
T T
ROUBLESHOOTING IPS
If you are having trouble programming HomeLink®,
here are some of the most common solutions:
●
Replace the battery in the garage door opener hand-
held transmitter.
●
Push the LEARN button on the garage door opener to
complete the training for a rolling code.
●
Did you unplug the device for programming and
remember to plug it back in?
If you have any problems, or require assistance, please
call toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
WARNING!
●
Vehicle exhaust contains carbon monoxide, a
dangerous gas. Do not run your vehicle in
the garage while programming the transmitter.
Exhaust gas can cause serious injury or death.
●
Your motorized door or gate will open and
close while you are programming the universal
transmitter. Do not program the transmitter if
people, pets or other objects are in the path of
the door or gate. Only use this transmitter with a
garage door opener that has a "stop and reverse"
feature as required by Federal safety standards.
This includes most garage door opener models
manufactured after 1982. Do not use a garage
door opener without these safety features.

EXTERIOR LIGHTS

H S
EADLIGHT WITCH
The headlight switch is located on the left side of the
instrument panel. This switch controls the operation
of the headlights, parking lights, automatic headlights
(if equipped), instrument panel light dimming, cargo
light/trailer spotter lights (if equipped), and fog lights
(if equipped).
(Continued)
WARNING!