Battery Saver On/Battery Saver Mode Message - Electrical Load Reduction Actions - If Equipped - RAM 1500 2025 Owner's Manual

Standard Mode
When "Standard" mode is selected, the HUD
image is split into thirds with the speed limit
indicator shown to the left, vehicle speed in the
center, and turn-by-turn navigation to the right.
○
Advanced: Speed, Speed Limit, Navigation, Driver
Assist (ACC/Cruise, Adaptive Driving Assist, Active
Lane Management), Gear
Advanced Mode
When "Advanced" mode is selected, the
HUD displays the vehicle speed, turn-by-turn
navigation, speed limit, driver assist function(s),
and current gear.
○
Custom 1: Speed, Speed Limit
○
Custom 2: Speed, Speed Limit, Navigation
○
Custom 3: Speed, Speed Limit, Navigation, Driver
Assist (ACC/Cruise, Adaptive Driving Assist, Active
Lane Management)
○
Custom 4: Speed, Speed Limit, Navigation, Driver
Assist (ACC/Cruise, Adaptive Driving Assist, Active
Lane Management), Gear
●
Display Height
●
Brightness
NOTE:
●
The HUD basic settings (Brightness, Display Height
and Non Custom layouts), are controlled through the
Settings Screen in the Instrument Cluster
104.
●
HUD custom content layout preferences can be
selected through your touchscreen. For more
information, please refer to your Uconnect Owner's
Manual Supplement.
B S O /B S
ATTERY AVER N ATTERY
M — E L
ESSAGE LECTRICAL OAD
A — I E
CTIONS F QUIPPED
This vehicle is equipped with an Intelligent Battery
Sensor (IBS) to perform additional monitoring of the
electrical system and status of the vehicle battery.
In cases when the IBS detects charging system failure,
or the vehicle battery conditions are deteriorating,
electrical load reduction actions will take place to
GETTING TO KNOW YOUR INSTRUMENT PANEL
extend the driving time and distance of the vehicle.
This is done by reducing power to or turning off non-
essential electrical loads.
Load reduction is only active when the engine is
running. It will display a message if there is a risk of
battery depletion to the point where the vehicle may
stall due to lack of electrical supply, or will not restart
after the current drive cycle.
When load reduction is activated, the message "Battery
Saver On Some Systems May Have Reduced Power" will
appear in the instrument cluster.
These messages indicate the vehicle battery has a low
state of charge and continues to lose electrical charge
at a rate that the charging system cannot sustain.
NOTE:
ð
●
The charging system is independent from load
page
reduction. The charging system performs a
diagnostic on the charging system continuously.
●
If the Battery Charge Warning Light is on it may
indicate a problem with the charging system
page 113.
The following are electrical loads that may be switched
M
AVER ODE
off (if equipped), and vehicle functions which can be
R
affected by load reduction:
EDUCTION
●
Heated Seats / Vented Seats / Heated Wheel
●
Rear Defroster And Heated Mirrors
●
HVAC System
●
115 Volts AC Power Inverter System
●
Audio and Telematics System
Loss of the battery charge may indicate one or more of
the following conditions:
111
3
ð