Driver Memory Settings - If Equipped; Programming The Memory Feature - RAM 1500 2025 Owner's Manual

Three Temperature Settings:
●
Press the heated steering wheel button once to turn
the HI setting on.
●
Press the heated steering wheel button a second
time to turn the MED setting on.
●
Press the heated steering wheel button a third time
to turn the LO setting on.
●
Press the heated steering wheel button a fourth time
to turn the heating elements off.
NOTE:
The engine must be running for the heated steering
wheel to operate.
For information on use with the Remote Start system,
ð
see page 23.
WARNING!
●
Persons who are unable to feel pain to the
skin because of advanced age, chronic illness,
diabetes, spinal cord injury, medication, alcohol
use, exhaustion, or other physical conditions
must exercise care when using the steering
wheel heater. It may cause burns even at low
temperatures, especially if used for long periods.
●
Do not place anything on the steering wheel
that insulates against heat, such as a blanket or
steering wheel covers of any type or material. This
may cause the steering wheel heater to overheat.
DRIVER MEMORY SETTINGS — IF
EQUIPPED
This feature allows the driver to save up to two different
memory profiles for easy recall through a memory
switch. Each memory profile saves desired position
settings for the following features:
●
Driver's seat position
●
Easy Entry/Exit seat operation (if equipped)
●
Power adjustable pedals (if equipped)
●
Side mirrors
●
A set of desired radio station presets
NOTE:
Your vehicle is equipped with two key fobs, each can be
linked to either memory position 1 or 2.
The memory settings switches are located on the front
door panels, next to the door handle, and consists of
two or three buttons, depending on trim level:
●
The seat massage button (three button configuration
only), which is used to activate the massage
function.
●
The (1) and (2) buttons which are used to recall
either of two saved memory profiles.
GETTING TO KNOW YOUR VEHICLE
Memory Settings Switch
P T M F
ROGRAMMING HE EMORY
To create a new memory profile, perform the following:
NOTE:
Saving a new memory profile will erase the selected
profile from memory.
1. Place the vehicle's ignition in the ON/RUN position
(do not start the engine).
2. Adjust all memory profile settings to desired
preferences (i.e., driver's seat, outside mirrors,
adjustable pedals (if equipped), and radio station
presets).
3. Push the the desired memory button (1 or 2) within
five seconds. The instrument cluster display will
display which memory position has been set.
NOTE:
Memory profiles can be set without the vehicle in PARK,
but the vehicle must be in PARK to recall a memory
profile.
29
2
EATURE