Power Door Locks - If Equipped; Power Side Steps - If Equipped - RAM 1500 2025 Owner's Manual

Front Door Lock Knob
Rear Door Lock Knob
WARNING!
●
For personal security and safety in the event of a
collision, lock the vehicle doors before you drive as
well as when you park and leave the vehicle.
●
When exiting the vehicle, always make sure the
keyless ignition is in the OFF position, remove the
key fob from the vehicle and lock your vehicle.
●
Never leave children alone in a vehicle, or with
access to an unlocked vehicle. Allowing children
to be in a vehicle unattended is dangerous for
a number of reasons. A child or others could
be seriously or fatally injured. Children should be
warned not to touch the parking brake, brake
pedal or the gear selector.
●
Do not leave the key fob in or near the vehicle,
or in a location accessible to children, and do not
leave the Keyless Enter 'n Go™ Ignition in the ACC
or ON/RUN position. A child could operate power
windows, other controls, or move the vehicle.
P D L
OWER OOR OCKS
The power door lock switches are located on each front
door panel. Push the switch to lock or unlock the doors.
(Continued)
Power Door Lock Switches
WARNING!
— I E
F QUIPPED
GETTING TO KNOW YOUR VEHICLE
The driver's door will unlock automatically if the key fob
is detected inside the vehicle when the door lock button
on the front door panel is used to lock the door. This
will occur for two attempts. Upon the third attempt, the
doors will lock even if the key fob is inside.
NOTE:
If the key fob is located next to a mobile phone,
laptop, or other electronic device, the wireless signal
may get blocked, and the driver's door may not unlock
automatically.
If the door lock switch is pushed while the ignition is in
ON/RUN and the driver's door is open, the doors will not
lock.
If a rear door is locked, it cannot be opened from inside
the vehicle without first unlocking the door. The door
may be unlocked manually by raising the lock knob.
P S S — I E
OWER IDE TEPS F QUIPPED
The Power Side Steps will extend a step for easier entry
and exit of the vehicle.
When configured for Auto mode, the Power Side Steps
will deploy when any of the doors are opened, or when
the deploy setting is activated through the touchscreen.
When configured for Store mode, the steps will not
deploy unless the setting is selected manually through
the Controls menu within the touchscreen.
If the vehicle speed exceeds 4 mph (7 km/h), or if the
retract setting is selected within Uconnect Settings
page 203, the steps will retract.
25
2
ð