Oil Life Reset - RAM 1500 2025 Owner's Manual

106 GETTING TO KNOW YOUR INSTRUMENT PANEL
●
Press OK to select the tile and navigate to the
selected submenu and press OK again to add your
selection to your tile view
●
If equipped, the main menu options of the home
screen are Driver Info, Vehicle Info, Navigation,
Audio, and Off Road
Custom Tile Screen Example
You can customize your Instrument Cluster Display with
up to five tiles that may consist of the following:
NOTE:
These options may vary based on your vehicle trim
level.
●
Navigation
○
Route Set / Route Not Set
○
Trip A / Trip B
●
Vehicle Info
○
Coolant Temp
○
Trans Temp
○
Oil Temp
○
Oil Pressure
○
Battery Voltage
○
Oil Life
○
Tire Pressure
○
Fuel Economy
○
Air Suspension
●
Driver Info
○
Driver Assist
●
Audio
○
Audio Info
●
Off Road
○
Selec-Terrain / Air Suspension Status
○
Steering Angle
○
Pitch
○
Roll
●
Trailer Tow
○
Trailer Trip
○
Trailer Brake
○
Trailer Tire Pressure Monitor
O L R
IL IFE ESET
Your vehicle is equipped with an
engine oil change indicator system.
The "Oil Change Required" message
will display in the instrument cluster
display for five seconds after a single
chime has sounded, to indicate the
next scheduled oil change interval.
The engine oil change indicator system is duty cycle
based, which means the engine oil change interval may
fluctuate, dependent upon your personal driving style.
Unless reset, this message will continue to display each
time you place the ignition in the ON/RUN position. To
turn off the message temporarily, push and release the
OK or arrow buttons. To reset the oil change indicator
system (after performing the scheduled maintenance),
refer to the following procedure:
1. Without pressing the brake pedal, push the
ENGINE START/STOP button and place the ignition
in the ON/RUN position (do not start the engine).
2. Push and release the down
scroll downward through the main menu to
"Vehicle Info."
3. Push and release the right
access the "Oil Life" screen.
4. Push and hold the OK button to reset oil life. If
conditions are met, the gauge and numeric display
will update to show 100%. If conditions are not met
a pop-up message of "To reset oil life engine must
be off with ignition in run" will be displayed (for five
seconds), and the user will remain at the Oil Life
screen.
5. Push and release the up
button to exit the submenu screen.
NOTE:
If the indicator message illuminates when you start the
vehicle, the oil change indicator system did not reset. If
necessary, repeat this procedure.
Scan me
arrow button to
arrow button to
or down arrow