Uconnect Voice Recognition - If Equipped; Introducing Voice Recognition; Basic Voice Commands; Get Started - RAM 1500 2025 Owner's Manual

Wing Extended (Left-Hand Side Shown)
NOTE:
The head restraints should only be removed by qualified
technicians, for service purposes only. If either of the
head restraints require removal, see an authorized
dealer.
WARNING!
●
All occupants, including the driver, should not
operate a vehicle or sit in a vehicle's seat until the
head restraints are placed in their proper positions
in order to minimize the risk of neck injury in the
event of a crash.
●
Head restraints should never be adjusted while
the vehicle is in motion. Driving a vehicle with the
head restraints improperly adjusted or removed
could cause serious injury or death in the event of
a collision.
Rear Head Restraints
The outboard head restraints are non-adjustable, but
can be folded down for improved rearward visibility.
Push the button on the outboard side of the head
restraint to release. To return the head restraint to its
upright position, push up on the head restraint until it
locks back into place.
Release Button
WARNING!
Sitting in a seat with the head restraint in its lowered
position could result in serious injury or death in
a collision. Always make sure the outboard head
restraints are in their upright positions when the seat
is to be occupied.
The center head restraint is not adjustable or
removable.
NOTE:
The head restraints should only be removed by qualified
technicians, for service purposes only. If any of the
head restraints require removal, see an authorized
dealer.
ð
For child restraint tethering, see page
GETTING TO KNOW YOUR VEHICLE
UCONNECT VOICE RECOGNITION — IF
EQUIPPED
I V
NTRODUCING OICE
Start using Uconnect Voice Recognition with these
helpful quick tips. It provides the key Voice Commands
and tips you need to know to control your vehicle's
Voice Recognition (VR) system.
B V C
ASIC OICE OMMANDS
The following basic Voice Commands can be given at
any point while using your Uconnect system.
Push the VR button
say the vehicle's "Wake Up" word, "Hey Uconnect". After
the beep, say:
●
"Cancel" to stop a current voice session.
●
"Help" to hear a list of suggested Voice Commands.
●
"Repeat" to listen to the system prompts again.
Notice the visual cues that inform you of your Voice
Recognition system's status.
NOTE:
On Uconnect 5 systems, the factory default "Wake
Up" word is set to "Hey Uconnect" and can be
reprogrammed through the Uconnect Settings.
G S
ET TARTED
The VR button is used to activate/deactivate your
Voice Recognition system.
254.
Helpful hints for using Voice Recognition:
39
R
ECOGNITION
2
or for the Uconnect 5/5 NAV,