Turning Active Lane Management On Or Off; Active Lane Management Warning Message - RAM 1500 2025 Owner's Manual

176 STARTING AND OPERATING
a visual warning in the instrument cluster, as well
as a steering assist torque (if configured in Uconnect
Settings), to prompt the driver to remain within the
lane boundaries. If the driver continues to drift out
of the lane, the system provides a flashing visual
warning through the instrument cluster display as well
as a haptic steering wheel vibration (if configured in
Uconnect Settings) when the vehicle crosses the lane
boundary.
NOTE:
When operating conditions have been met, the Active
Lane Management system will monitor if the driver's
hands are on the steering wheel and provides an
audible and visual warning to the driver if removed.
The system will cancel if the driver does not return their
hands to the wheel.
T A L M
URNING CTIVE ANE ANAGEMENT
O
FF
The Active Lane Management button can
be located above or to the right of the
Uconnect display.
To turn the system on, push the Active Lane
Management button (LED turns off). A message is
shown in the instrument cluster display.
To turn the system off, push the button again (LED turns
on).
NOTE:
The Active Lane Management system will retain the last
system state on or off from the last ignition cycle when
the ignition is placed in the ON/RUN position.
A L M
CTIVE ANE ANAGEMENT
M
ESSAGE
The Active Lane Management system will indicate the
current lane drift condition through the instrument
cluster display.
When the system is on, the lane lines are gray.
O O
N R
System On (Gray Lines)
Left Lane Departure — Only Left Lane Detected
●
When the system is on and only the left lane
marking has been detected, and the system is
ready to provide visual warnings in the instrument
cluster display and a vibration and/or steering assist
warning in the steering wheel if a lane departure
occurs.
●
When the system senses the lane line has been
approached (but not crossed), the left lane line will
change to solid yellow and the system will provide
steering assist torque (if programmed in Uconnect
Settings).
●
W
When the system senses the lane line is being
ARNING
crossed, the left lane line will change to flashing
yellow, and the system will provide haptic steering
wheel vibration (if programmed in Uconnect
Settings).
NOTE:
The Active Lane Management system operates with
similar behavior for a right lane departure when only
the right lane marking has been detected.
Left Lane Departure — Both Lanes Detected
●
When both lane markings have been detected, the
system is ready to provide visual warnings in the
instrument cluster display and a vibration and/or
steering assist warning in the steering wheel if a lane
departure occurs.
Lane Crossed (Flashing Yellow Line)