Active-Level Four Corner Air; Suspension System - If Equipped; Description - RAM 1500 2025 Owner's Manual

136 STARTING AND OPERATING
2WD OR 4WD AUTO OR 4WD LOCK TO 4WD
LOW
NOTE:
When shifting into or out of 4WD LOW some gear
noise may be heard. This noise is normal and is not
detrimental to the vehicle or occupants.
Shifting can be performed with the vehicle rolling 2 to 3
mph (3 to 5 km/h) or completely stopped. You can use
either of the following procedures:
Preferred Procedure
1. With the engine running, slow the vehicle to 2 to 3
mph (3 to 5 km/h).
2. Shift the transmission into NEUTRAL.
3. While still rolling, push the desired position on the
transfer case control switch.
4. After the desired position indicator light is on (not
flashing), shift the transmission back into gear.
Alternate Procedure
1. Bring the vehicle to a complete stop.
2. With the ignition switch in the ON/RUN position
and the engine running, shift the transmission into
NEUTRAL.
3. Push the desired position on the transfer case
control switch.
4. After the desired position indicator light is on (not
flashing), shift the transmission back into gear.
NOTE:
●
If Steps 1 or 2 of either the Preferred or Alternate
Procedure are not satisfied prior to attempting
the shift, then the desired position indicator light
will flash continuously while the original position
indicator light is on, until all requirements have been
met.
●
The ignition switch must be in the ON/RUN position
for a shift to take place and for the position indicator
lights to be operable. If the ignition switch is not in
the ON/RUN position, the shift will not take place
and no position indicator lights will be on or flashing.

ACTIVE-LEVEL FOUR CORNER AIR

SUSPENSION SYSTEM — IF EQUIPPED
D
ESCRIPTION
The air suspension system provides full-time load-
leveling capability along with the benefit of being able
to adjust vehicle height by using the toggle switch.
Air Suspension Switch
1 — Off-Road 2 Indicator (Customer Selectable)
2 — Off-Road 1 Indicator (Customer Selectable)
3 — Normal Ride Height Indicator (Customer
Selectable)
4 — Aero Height Indicator (Customer Selectable)
5 — Entry/Exit Height Indicator (Customer Selectable)
●
Off-Road 2 (OR2) (Raises the vehicle approximately
2 inches [51 mm]) – This position is intended for
off-road use only where maximum ground clearance
is required. To enter OR2, push the height selector
switch up twice from the NRH position or once from
the OR1 position while vehicle speed is below 20
mph (32 km/h). While in OR2, if the vehicle speed
exceeds 25 mph (40 km/h) the vehicle height will
be automatically lowered to OR1. Off-Road 2 may not
be available due to vehicle payload, an instrument
cluster message is displayed when this occurs
page 104.
CAUTION!
If the vehicle is in Off-Road 1 or Off-Road 2
setting, be aware of your surroundings, you may
not have the clearance required for certain areas
and vehicle damage may occur.
●
Off-Road 1 (OR1) (Raises the vehicle approximately 1
inch [26 mm]) – This position should be the primary
position for all off-road driving until Off-Road 2 (OR2)
is needed. A smoother and more comfortable ride
will result. To enter OR1, push the height selector
switch up once from the NRH position while the
vehicle speed is below 35 mph (56 km/h). When
in the OR1 position, if the vehicle speed remains
between 40 mph (64 km/h) and 50 mph (80 km/h)
for greater than 20 seconds or if the vehicle speed
ð