Section Five General Points (Users Instructions) - Infinity 600 FL Owner's Manual

SECTION FIVE General Points (users instructions)

Like all appliances incorporating an aerated burner a low frequency noise may be heard, particularly on the low
setting, this is quite normal and does not affect the operation of the appliance.
It is advised that a competent person service the 600 FL fire annually. The fire is more likely to provide trouble-free
operation.
Dulling and slight discoloration inside the firebox will occur adding to the realism of the appliance. This is normal.
It is important that: -
The chimney or flue is checked annually to ensure clearance of combustion products. This can be inspected by
removing the inner firebox and removal of the inspection covers located on the back and top of the outer firebox.
This can be obtained by doing the following.

Carefully remove the glass panel and side covers and inlet grill refer to section 3.

Remove the log fuel bed shapes.

Lift out the air tray assembly from the location points within the shelf.

Remove the two screw retaining the gas connection cover from within the burner
shelf and remove cover. Shut down restrictor elbow and disconnect the 8mm
inlet nut.

Undo the three fixing screws from the burner tray and lift out burner tray
assembly taking care not to damage the liners.

Remove the six M4 nuts from the front face of the inner firebox.

Taking care not to damage the top liner remove the three fixing screw from the
top of the inner firebox.

Carefully pull the inner firebox forward to clear the outer firebox assembly.

Remove the inspection plates located within the outer firebox taking care not to
damage the sealing gaskets.

After inspection for clearance is completed reassemble in reverse order.
The only user removable parts are: -

Refractory Fire bed Components

Side covers and air grill.

Glass panel top fixing bracket.

Glass panel.
www.charltonandjenrick.co.uk 15 LT6125 (ISS 13)