Mount Loudspeakers - Cisco TelePresence MX800 Installation Manual

Installation guide for Cisco TelePresence MX800 Dual - Floor stand
17

Mount loudspeakers

H
Three loudspeakers are pre-installed. Follow
steps 1-3 for the remaining eight loudspeakers.
Connect the cable to the loudspeaker. Use
1
the cable that is marked with the correct
loudspeaker position. Loudspeaker cable 1
above the right monitor is not used.
Enter the loudspeaker onto the speaker clip.
2
Make sure that no cables are pinched.
78-100574-02A0 | 2016 JUNE | © 2016 Cisco Systems, Inc. All rights reserved.
The loudspeaker cables
are marked with a
number. These numbers
must match the position
of the loudspeakers, as
shown here.
Cable number 1, above
the right monitor, is not
used.
Fasten with one screw.
3
8 × PT4x10 (one for each loudspeaker)
1
2
3
4
5
6
2
3
4
5
6
Page 23