Copying While Printing; On-Line/Off-Line Button; Power Saving - Xerox WorkCentre XE80 User Manual

Copying While Printing

In order to perform a copy job while the machine is printing:
1. Set up the copy job while the machine is printing.
2. Press Start. The current page will finish printing, then the copy job will
start.
3. When you complete the copy job, the factory preset is 1 minute before it
reverts to print mode or touch the On-line/Off-line button to take it back
to print mode. The machine will resume printing if pages are pending.

On-line/Off-line Button

Alternates between the On-line and Off-line status
The On-line/Off-line button can be pressed to interrupt a print job to run a
copy job. When the copy job is complete, touch the On-line/Off-line button
to take it back to print mode or it will revert to print mode automatically after
1 minute.
When the light is on printing is in progress. When the light is off there is no
communication to or from the PC. When the light is blinking data is being
received from the PC.

Power Saving

For assistance in changing the preset values refer to Programmable
Features.
Power Reductions automatically reduce power consumed by the
WorkCentre when the WorkCentre has not been used for a set period of
time. There are two modes of power reduction; Power Save, and Power
Shut-off.
Power Save – In this mode, the fuser is maintained at a lower heat level,
thereby saving power. The Ready Indicator will flash and the other
indicators will remain on. To copy from Power Save select the desired
features and press Start. The copies will be made automatically.
Power Shut-Off – This mode saves more power than the Power Save
Mode, but requires more time before copying can begin. When the copier
enters the power shut-off the Ready Indicator will flash and the other
indicators will turn off. To copy from the power shut-off , press the Start
button, then, select the desired features and press Start again. The copies
will be made automatically.
21