Table of Contents
Advertisement
3.
How to Set up
Setting Menu 6: Optional Logging settings
<The installation conditions for optional plug-in module>
ME-0000BU-SS96 or ME-0000BU25-SS96 installation
You will set the optional logging.
In the operating mode, press
operation.
Setting Menu
DISPLAY
SET
①Option selection
DISPLAY
SET
②Logging ID
DISPLAY
SET
③Logging data clear
DISPLAY
SET
and
simultaneously for 2 seconds or more to enter the following
RESET
SET
Select 6 in the setting menu number.
*Refer to the right figure.
Select option (optional logging) or built-in logging.
Log.PLUG
(Optional logging)
The explanation here is about optional logging settings.
For the analog output settings, refer to 3.10.
For the built-in logging settings, refer to 3.9.
Set the ID number of logging optional module.
Settable ID: 001 to 255
When the installed logging optional module has the
setting ID number, the number is displayed as the initial
value.
If this instrument does not receive the ID number from the logging
Note
optional module, this screen will not be displayed. Wait until it
receives.
Clear the data that the logging optional module stores.
no
(Not clear)
When you select 'yES' at the above setting, the screen
appears again to confirm the determination.
no
(Not clear)
Log.buiLt
(Built-in logging)
yES
(Clear)
yES
(Clear)
45
Advertisement
Table of Contents
