Table of Contents
Advertisement
7.
Installation
How to insert/remove SD memory card
■When inserting the SD memory card:
Insert the SD memory card straight into the SD memory slot until you hear a click.
・Be sure to use a SD memory card, EMU4-SD2GB, produced by Mitsubishi Electric
Corporation. Using a SD memory card not produced by Mitsubishi Electric Corporation
CAUTION
may cause a trouble such as data corruption in the card or system stop.
・Insert the SD memory card with the write protect switch OFF. If the write protect switch
is ON, the logging unit will not communicate with the card.
■When removing the SD memory card:
①Check that SD C.LED is OFF.
②Insert the SD memory card until you hear a click.
③The SD memory card comes out automatically.
②Inset the SD memory card.
If you removed the SD memory card while the instrument communicates with the card,
CAUTION
this might cause data corruption in the card or failure of the instrument or card. After
checking that SD C.LED is OFF, remove the card.
①Check that SD C.LED is OFF.
③The SD memory card comes out.
115
Advertisement
Table of Contents
