CLEAR SCANNER
FAULT LOG
CLEAN CAL ZONE
COMPONENT TESTS
XEROX WIDE FORMAT COPY SYSTEM
The second and third lines contain the log entry information in columnar
format. The first column indicates the log entry number. The second
column indicates the fault code recorded in the log. The third column is
the value of the internal Scanner Usage Meter at the time the fault was
detected.
Below is an example of the SCANNER FAULTS (COUNTS) screen.
SCANNER FAULTS (COUNTS)
LAST CLEARED:
01
01-02
02
01-03
Scanner Faults (Counts) Screen
8. Use the Previous or Next key to scroll through the listing.
The entries are presented three to a screen. You can view all valid
entries in the Scanner Fault Log from this screen. Empty log entries are
not displayed.
9. When finished viewing the fault data, press the Exit key to return
to the SCANNER DIAGNOSTICS menu screen.
The CLEAR SCANNER FAULT LOG option is for use by the Customer
Service Engineer only and requires the entry of the diagnostic password.
It allows the Customer Service Engineer to erase the contents of the
Scanner Fault Log.
The CLEAN CAL ZONE (Clean Calibration Zone) provides the user with
a quick way to move the Calibration Motor to the cleaning position. There
are two selections CLEANING POSITION AND HOME POSITION.
CLEAN CAL ZONE
POSITION:
The COMPONENT TESTS option of the SCANNER DIAGNOSTICS
menu provides a sub-menu of the following menu choices:
•
MOTOR SPEED - Enables the Customer Service Engineer to
adjust the Scan System motor speed and correct magnification
errors in the process direction. The diagnostic password is
required for this function.
•
LEAD EDGE/TRAIL EDGE - Enables you to execute the lead
edge/trail edge diagnostic.
2001
2476
2402
CLEANING POSITION
Clean Cal Zone Screen
Main Menu • 129