Tab Options - Xerox 6030 User Manual

PUNCH OPTIONS
MARGIN OPTIONS
CROSSFOLD OPTIONS
XEROX WIDE FORMAT COPY SYSTEM
TAB: USE PROGRAM
The PUNCH OPTIONS feature enables you to override the pre-
programmed hole punch settings for the selected finishing program. The
choices are ALWAYS ON, ALWAYS OFF, and USE PROGRAM
SETTING. USE PROGRAM SETTING is the factory default setting.
PUNCH: USE PROGRAM
The MARGIN OPTIONS feature enables you to override the pre-
programmed margin settings for the selected finishing program. The
choices are ALWAYS OFF and USE PROGRAM SETTING. Note that
ALWAYS ON is not an available setting. USE PROGRAM SETTING is
the factory default setting.
MARGIN: USE PROGRAM
NOTE: When using the Scan System's width detection sensors, if the
document is a little bit off-center, this could cause problems for folding,
especially for A, B, and C size documents. When using the sensors to
detect the width of your document, you must center the document as you
feed it into the Scan System.
The CROSSFOLD OPTIONS feature enables you to override the pre-
programmed crossfold settings for the selected finishing program. The
choices are ALWAYS ON, ALWAYS OFF, and USE PROGRAM
SETTING. USE PROGRAM SETTING is the factory default setting.

TAB OPTIONS

Tab Options Screen
PUNCH OPTIONS
Punch Options Screen
MARGIN OPTIONS
Margin Options Screen
Special features keys • 73