Xerox DocuColor 40 User Manual page 48

2
2-12 Performing Setup from the Control Panel
T N S
O ACCESS ETWORK ETUP OPTIONS
1. Confirm that the network cable is connected to the DocuColor 40 CP.
During Network Setup, the DocuColor 40 CP queries the network for zones, servers,
and server-based queues. If you perform Network Setup without a connected and
functioning network, default settings are used that may not meet your needs.
2. Choose Network Setup from the main Setup menu.
3. Choose Port Setup from the Network Setup menu.
4. To use Ethernet, choose Ethernet Setup from the Port Setup menu, and enter the
appropriate settings.
5. If the Token Ring option is installed, choose Token Ring Setup and enter the appropri-
ate settings.
6. To print to the parallel port, choose Parallel Port Setup from the Port Setup menu, and
enter the appropriate settings.
7. When you have finished entering port settings, choose Exit Port Setup and then choose
Protocol Setup.
8. Enter the appropriate settings for the protocol or protocols you will use.
9. When you have finished entering protocol settings, choose Exit Protocol Setup and
then choose Service Setup.
10. Enter the appropriate settings for the services you will use.
The options are described in detail in the following pages.
T N S :
O EXIT ETWORK ETUP
1. When you have finished entering service settings, choose Exit Network Setup.
2. Choose Yes when prompted to save changes.
3. From the main Setup menu, choose another Setup or choose Exit Setup.
: