Pre-Installation And Application Warnings; Key Type - Directechs DIRECTED DB3 Installation Manual

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as
START HERE
well as bringing awareness to any operational or vehicle limitations.
Compatibilities and Requirements
T-Harness
T-Harness is not compatible.
compatible
Vehicle Takeover
Firmware notes
Important! The master key is required to complete the module programming successfully.
Š
Keysense wire: Do not connect this wire in the installation for each of these vehicles or you will encounter issues when attempting to
Š
start the vehicle.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
Š
Refer to the Vehicle connections section following the installation diagram.
Š
Footnotes
[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory
hood pin, or if not supported in data.
[2] Tach wire: An optional connection required on some remote starters, which do not support a tach signal in D2D.
[3] Parking light output: Only required if parking lights are not supported in data.
[4] Remote starter: Must be programmed during flashing to unlock before start and lock after start. This can be done when
flashing the firmware under the Data Feature Configuration section and enabling Safelock under Smart OEM Alarm Control.
This Unlock output must also be programmed for double pulse.

Key type

Some Toyota 2010+ models have different encryption types. Please look at your key blade and identify the markings.
H-stam ped keys
For vehicles with H-stamped keys, see
the TL10 firmware.
H
5
403.TL7 2.36 2011 Toyota Tacoma (G Key)
©2023 VOXX•DEI LLC. All rights reserved.
Refer to the Quick Reference Guide section for more details.
G-stam ped keys
For vehicles with G-stamped keys, see
the TL5 & TL7 firmware.
Keys required for 1 Keys required
programming for operation
Standard Key
For vehicles with dot-stamped keys,
see the TL11 firmware.
Note: Some replacement keys
may not have any markings on
the key.
0