Control Menus - Martin MAC One User Manual

Control menus

Default settings are given in bold print.
Menu level 1 Menu level 2
DMX SETUP
DMX ADDRESS 1 - 493
COMPACT
BASIC
CONTROL MODE
LUDICROUS
COMPACT DIRECT
DMX UNIVERSE 1 - 64000
ETHERNET SETUP
XXX.XXX.XXX.XXX
PART 1 MSB
IP ADDRESS PART 2
PART 3
PART 4 LSB
XXX.XXX.XXX.XXX
SUBNET MASK
EDIT SUBNET
MASK
MAC ADDRESS XX:XX:XX:XX:XX:XX
RESET IP SETUP RESET
FIXTURE ID
0 - 9999
PERSONALITY
PAN INVERT
TILT INVERT
PAN/TILT
LIMIT PAN/TILT
30
Menu level 3
XXX.XXX.XXX.XXX
XXX.XXX.XXX.XXX
ARE YOU SURE?
→YES/NO
ON/OFF
ON/OFF
LIMIT ENABLE/
DISABLE
PAN MIN
PAN MAX
TILT MIN
TILT MAX
RESET PAN/TILT
LIMITS → ARE YOU
SURE? → YES/NO
®
Martin MAC One User Manual Rev. B
Notes
Set DMX address (default address =
1). The DMX address range is limited
so that the fixture will always have
enough DMX channels within the 512
available.
Set DMX control mode
Set DMX universe.
Display fixture's static IP address
Set far left block (most significant byte)
of IP address
Set middle left block of IP address
Set middle right block of IP address
Set far right block (least significant byte)
of IP address
Display fixture's subnet mask
Set subnet mask with 1-bit increments
from the left
Display fixture's MAC address
Reset static IP address and subnet
mask to factory default values
User-settable 4-digit fixture ID number
(default = 0)
Invert pan movement
Invert tilt movement
Enable/disable pan/tilt limits
Set minimum pan angle limit
Set maximum pan angle limit
Set minimum tilt angle limit
Set maximum tilt angle limit
Remove pan and tilt limits (reset pan
and tilt ranges to factory defaults)