Control Panel Menus - Martin MAC Viper AirFX User Manual

Control panel menus

Applicable when running firmware version 1.4.0.
Menu level 1 Menu level 2
DMX ADDRESS 1 – XXX
BASIC
CONTROL MODE
EXTENDED
FIXTURE ID 0 – 9999
PAN/TILT
SPEED
DIMMER CURVE
PERSONALITY
FOCUS
TRACKING
AUTO LAMP ON
DMX LAMP OFF
DMX RESET
Menu level 3 Menu level 4
User-settable fixture ID number
PT SWAP ON/OFF
PAN INVERT ON/OFF
TILT INVERT ON/OFF
NORMAL
FAST
PAN/TILT
SLOW
FOLLOW P/T
NORMAL
EFFECT
FAST
SLOW
LINEAR
SQUARE LAW
INV SQ LAW
S-CURVE
DISABLED
NEAR
MEDIUM
FAR
OFF
ON
DMX
ON
OFF
ON
OFF
Table 4: Control menus
Control panel menus
Notes (Default settings in bold print)
DMX address (default address = 1). The
DMX address range is limited so that the
fixture will always have enough DMX
channels within the 512 available.
16-bit basic DMX mode with 2-channel
(coarse and fine) control of aerial effect
gobo indexing and speed, pan and tilt
16-bit extended DMX mode: basic mode
plus fine control of dimmer, zoom and
focus. Five channels are also reserved for
future effects.
0
DMX pan channel controls tilt, tilt channel
controls pan
Reverse DMX pan control: right → left
Reverse DMX tilt control: down → up
Normal speed pan and tilt
Optimize pan/tilt movement for speed
Optimize pan/tilt movement for
smoothness
Effects speed follows the speed setting
applied to pan and tilt via DMX or in
control menu
Normal effects speed
Optimize effects movement for speed
Optimize effects movement for
smoothness
Optically linear dimming curve
Square law dimming curve
Inverse square law dimming curve
S-curve (fixture emulates incandescent
lamp voltage linear RMS dimming curve)
Disables zoom focus linking
Enables zoom focus linking, optimized for
short-throw projection (5 - 10 m)
Enables zoom focus linking, optimized
for medium-throw projection (10 - 20 m)
Enables zoom focus linking, optimized for
long-throw projection (20+ m)
Automatic lamp striking disabled
Lamp strikes automatically within 90
seconds of fixture being powered on
Lamp strikes automatically when the
fixture receives a DMX signal
Lamp can be powered off via DMX
Lamp cannot be powered off via DMX (can
be overridden: see DMX protocol)
Fixture can be reset via DMX
Fixture cannot be reset via DMX (can be
overridden: see DMX protocol)
27