Fixture Setup Using The Control Panel; Using The Control Menus - Martin ERA 700 Performance IP User Manual

Fixture setup using the control panel

This section explains how to adjust fixture settings using the menus available in the fixture's control
panel. You can find details of additional functions that are not available in the control panel in the
chapters on the Control/Settings DMX channel and on setup via RDM later in this user manual.
Any changes that you make to the fixture's settings are stored in memory when the fixture is powered
off.
You can find a complete map of the control menu structure in 'Control menus' on page 31.
A – Control panel display
B – Menu button
C – Down button
D – Up button
E – Enter button

Using the control menus

The control panel buttons are touch-sensitive. The control panel flashes briefly to confirm when a
keypress has been registered. The buttons have the following functions:
MENU
DOWN
UP
ENTER
Special keypress functions
•
Pressing the UP and DOWN buttons together rotates the control panel display through 180°.
•
Pressing the MENU and UP buttons together resets the entire fixture.
•
Pressing and holding the MENU button for two seconds opens a Shortcuts menu (see next page).
•
Holding the MENU button pressed while applying power puts the fixture into Service Mode. Pan
and tilt are disabled in order to avoid head movement causing problems during service operations
with the fixture powered on.
Cycling power and allowing the fixture to start up normally takes it out of Service Mode.
Martin
•
Activate the control menus, or
•
open the Shortcuts menu by holding for 2 seconds, or
•
return to the previous level of the menu structure, or
•
press to exit the menus
Scroll down a menu
Scroll up a menu
Confirm the selected function
®
ERA 700 Performance IP User Manual Rev. D
D
A
E
B
C
13