Martin MAC One User Manual page 11

Status LED
The Status LED L next to the control buttons indicates fixture status by showing a color:
• GREEN: All parameters normal.
• AMBER: Warning (service interval exceeded, for example).
If ERROR MODE is set to NORMAL, the warning message will be shown in the display.
-
If ERROR MODE is set to SILENT, the display must be activated by pressing the ENTER button to
-
display the warning message.
• RED: Error detected.
If ERROR MODE is set to NORMAL, the error message will be shown in the display.
-
If ERROR MODE is set to SILENT, display the error message by entering the menus and going to
-
SERVICE → ERROR LIST.
At the same time, the Status LED indicates DMX status by flashing or lighting constantly:
• FLASHING: No DMX signal detected.
• CONSTANT: Valid DMX signal detected.
The status LED remains active even if the display enters sleep mode.
Battery power
Warning! The fixture's lithium battery is not rechargeable. Do not try to recharge it. Battery replacement
must be carried out by an authorized Martin service agent with service instructions from Martin. If the
battery is discharged, contact an authorized Martin service agent for replacement.
The MAC One contains a lithium battery that gives access to the most important functions in the control
panel when the fixture is not connected to AC power. The following functions are available on battery
power:
• DMX address
• DMX Mode
• Fixture ID
• Personality settings (pan/tilt, cooling, fan clean mode, dimming curve, DMX reset, effect shortcuts, all
display settings, error mode)
• Default settings
• Information (Power On Hours and Power Cycles counters, Software version)
• Error list
To activate the display when the fixture is not connected to power, press the MENU button I. Press again
to enter the menus. The display extinguishes after 10 seconds with no user input and the control panel is
de-activated after 1 minute with no user input. Press the MENU button again to re-activate.
Shortcuts menu
Pressing and holding the MENU button for two seconds opens a small Shortcuts menu with the most
important menu items:
•
RESET ALL carries out a complete reset of the fixture with all its effects.
•
ROTATE DISPLAY rotates the control panel display through 180°. This function makes it easier to
read the control panel menus when changing from standing to hanging installation.
Settings stored permanently
The following settings are stored permanently in the fixture memory and are not affected by powering the
MAC One off and on or by updating the fixture software:
• DMX address and DMX universe
• IP address, subnet mask and MAC address
®
Martin MAC One User Manual Rev. B 11