Martin MAC One User Manual page 66

Disconnect the fixture from power at all times when the fixture is not in use.
Provide well-lit conditions to reduce the pupil diameter of anyone working on or near the
fixture.
Protection from injury
The fixture weighs 4.4 kg (9.7 lbs.) not including rigging hardware.
When the fixture is in use, it must be either:
•
fastened to a secure, stable structure such as a rigging truss, or
•
standing on a stable horizontal surface where it will not present a danger of tripping or
falling.
Install the fixture only as directed in this manual.
The fixture is not portable when in use.
Ensure that any supporting structure and/or hardware used can hold at least six (6) times
the weight of all the devices they support.
Make sure that all supporting structures and rigging hardware items (including safety cables
and fasteners) are in perfect condition, safely dimensioned, suitable for the installation
environment and will be stable under all weather and temperature conditions.
If suspending from a rigging structure, fasten the fixture to a truss or similar support using a
rigging clamp fastened to an omega bracket or using two rigging clamps bolted directly into
the M12 holes in the base of the fixture. Do not use a safety cable as the primary means of
support.
If the fixture is installed in a location where it may cause injury or damage if it falls, install as
directed in this manual a secondary attachment such as a safety cable that will hold the
fixture if a primary attachment fails. The secondary attachment must be approved by an
official body such as TÜV as a safety attachment for the weight that it secures, must comply
with DGUV 17 (BGV C1) or EN 60598-2-17 Section 17.6.6 and must be capable of bearing
a static suspended load that is six (6) times the weight of the fixture and all installed
accessories.
If the safety cable attachment point becomes deformed, do not suspend the fixture. Have
the fixture repaired by an authorized Martin service partner.
Allow enough clearance around the head to ensure that it cannot collide with an object or
another fixture when it moves.
Check that all external covers and rigging hardware are securely fastened.
Block access below the work area and work from a stable platform whenever installing,
servicing or moving the fixture. Make sure that there is no risk of injury from falling parts,
tools or other materials.
Do not operate the fixture with missing or damaged covers, shields or any optical
component.
Do not lift or carry the fixture by its head. Support the fixture by its base only.
In the event of an operating problem, stop using the fixture immediately and disconnect it
from power. Do not attempt to use a fixture that is obviously damaged.
Do not modify the fixture in any way not described in this manual or install other than
genuine Martin parts.
Refer any service operation not described in this manual to Martin Service or an authorized
Martin service partner.
®
Martin MAC One Safety and Installation Manual Rev. B 7