Control Settings; Overview; Manual Firing; Setting Fog Output Level - Martin JEM ZR44 HI-MASS User Manual

Control settings

O v e r v i e w
The unit is controlled using the remote control. You can control it in these ways:
 Manual firing by holding down the FOG button

Automatic fog bursts using a repeating timer
M a n u a l f i r i n g
Hold down the FOG button. The machine will produce fog until you release the
button.
If a long burst of fog is produced, after a time the fog output level will be
automatically reduced to keep the machine temperature within the operating
range. This allows continuous operation, so that the machine does not have to
stop and re-heat.
S e t t i n g f o g o u t p u t l e v e l
Set the knob to the desired output level while firing the machine. The fog output
level is always set by the current position of the knob, whether manually firing or
in timer mode.
S e t t i n g t h e T i m e r
FOG BUTTON: Will when the machine has reached operating temperature fire
the machine when pressed and held.
STAND-BY BUTTON: This turns the machines electronics on and off.
TIMER VALUE BUTTON: When the timer is being used, the timer values can be
adjusted by a factor of 8, i.e. a 5 second minimum run time becomes 40
seconds & a 10 second delay time becomes 1 minute 20 seconds.
TIMER ENGAGE: This will engage the timer to fire the machine according to the
present settings.
OUTPUT CONTROL: Turning this knob clockwise will increase the output of the
machine, if turned fully anti-clockwise there will be no output.
DELAY TIME CONTROL: This will adjust the amount of time the machine waits
between operating when the timer is engaged.
RUN TIME CONTROL: This will adjust the time the machine will operate for
when the timer is engaged.
POWER LED: This LED will light when the machine is switched on
CYCLE LED: This LED will light when the timer is engaged and the machine is
operating.
S e t t i n g t h e m a s t e r - s l a v e l i n k m o d e
It is possible to control several machines from either the onboard remote control
or the optional accessory digital remote. The machines are interconnected with
DMX cabling via either the 3 or 5-pin XLR sockets situated on the rear of the
machine
Dip switch 11 located on the rear of the machine must be set to the down
position on the master unit.
12 Control settings