JMA MOVE User Manual page 13

OPERATION AND FUNCTION
READING THE CODE ON AN ORIGINAL KEY
The original key has six duplication positions that are defined
by letters: A, B, C, D, E and F, as shown in the image below.
There are four different possible combinations at each posi-
tion on the key (defined by numbers), which are shown and
listed below:
!
1 2
The COMBINATION: 1 indicates that it should not be copied.
The COMBINATION: 2 indicates that there is a small cut in
the key. When it is somewhat larger, that corresponds to the
COMBINATION: 3. The COMBINATION: 4 is the largest of the
possible cuts in the key.
- Take the key and mark the combinations for each of the six
POSITIONS as shown below in the example:
POSITION A B C D E F
COMBINATION 3 4 1 2 4 2
NOTE: The series of numbers making up the combination is
the code for the key.
5.2.10 TUBULAR keys
See Figures 15A and 15B
- Use this cutter-tracer set: F-8 / P-8.
- Choose a pair of adapters to use based on the exterior
3 4
diameter of the key. There are four pairs that cover diameters
ranging from 5 mm to 12.5 mm.
- Secure the key in the "V" shaped part of the clamp exclusi-
vely designed for securing TUBULAR keys.
- It is important to secure the keys so that both are facing
the same direction.
- Adjust the tracer vertically.
- You will need to enable the tracer spring action system.
-
13
EN