Residual Risks; Electrical Risk - JMA MOVE User Manual

SAFETY MEASURES
2.2.4 General safety instructions
1. Never disconnect the earthing connec-
tion and make sure it is always connec-
ted correctly.
- Always disconnect the power supply before carrying out
any maintenance or cleaning.
- Always disconnect the power supply when the machine is
not in use.
- Check cable conditions regularly. If they are worn or dama-
ged, replace them immediately.
- Keep all electrical connections safe from water and other
liquids.
- Do not pull violently on the electrical power cord.
- Ensure that the electrical power cord does not come into
contact with oils, sharp objects or heat.
- During the duplication stages, always keep your hands on
the carriage assembly motion controls.
- Always work with dry hands free of grease and oil.
- Do not use the machine in hazardous, damp or wet loca-
tions.
- Everyone, and especially children, should keep a safe dis-
tance to prevent contact with the machine and the electri-
cal cables.

2.3 RESIDUAL RISKS

The MOVE key cutting machine has been designed with the
utmost care to ensure it is safe during transport, adjustment,
duplication and maintenance. Nonetheless, it is impossible
to eliminate all risks, whether for technological reasons or
for issues related to use of the machine (excessively complex
operations). Therefore, the following residual risks should be
taken into consideration when using the machine, as well as
the risks associated with its use:
1. RISKS RELATED TO THE INSTALLATION
LOCATION
The location where the machine is installed
may present risks that could impact correct
operation of the machine (temperature,
humidity, rain, etc.).
2.

ELECTRICAL RISK

Given that the machine is fitted with elec-
trical devices, a risk of electrocution exists
if a fault were to occur. The electrical power
cord should be fitted with suitable control
and protection devices (thermal magne-
tic circuit breaker and differential circuit
breaker).
3. MECHANICAL RISK
The machine is fitted with tools (cutter and
tracer) that are necessary for key dupli-
cation. The operator should therefore be
careful in order to prevent cutting their
hands when duplicating keys or replacing
the tools.
The operator should avoid wearing neckla-
ces, bracelets, rings and/or clothing that
could become trapped in the machine or
get caught up in the moving parts.
We recommend wearing a cap to cover
and contain your hair, especially for those
operators with long hair.
7 7
EN