JMA MOVE User Manual page 12

JMA
MOVE
- Secure the key in the part of the clamp exclusively designed
for securing MERCEDES keys, using the "TIP stop" technique.
- Adjust the tracer vertically.
- You will need to lock the tracer in place (disable the spring
action system).
- Insert the tracer into the blade channel on the key and lock
the machine head.
- If the tip of the tracer brushes against the bottom of the
blade channel on the key, raise the tracer slightly.
- We recommend making one initial pass and then another
finishing pass over the entire key profile. The key should be
cut from the key tip towards the key grip.
5.2.6 KA-2, KA-3 and KA-4 keys
See Figure 11
- A different cutter-tracer set will be used depending on the
key model to be copied. Please consult the table.
- You will need to use the AD-5º, AD-15º or AD-45º adapter
depending on the key model to be copied. Please consult the
table.
- Position the adapters on the clamp using the "TIP stop"
technique.
- Secure the keys into the adapters using the "SHOULDER
stop" technique.
- Adjust the tracer vertically.
- You will need to enable the tracer spring action system.
- Use the X axis carriage assembly locking handle to make
the task easier.
- Cut the first of the two rows of dimples.
- Turn the key so that the key grip remains facing the machi-
ne. Then cut the second row of dimples.
- Repeat this process on the other side of the key blade.
5.2.7 WIN-1D, WIN-2D, WIN-3D and WIN-4D keys
See Figure 12
- Use this cutter-tracer set: F-15 / P-15.
- Secure two key blanks in the clamp and use them to adjust
the tracer vertically.
- Using the P-WIN template, secure the keys in the clamp
KEY CUTTING MACHINE
with the bitting face up (as shown in the drawing).
- You will need to lock the tracer in place (disable the spring
action system).
- Insert the tracer into one of the dimples precisely and lock
the machine head at that height.
- Cut the key.
5.2.8 JIS-4P keys
See Figure 13
- Use this cutter-tracer set: F-11 / P-11.
- Use the AD-MJ adapter to secure the key in the clamp.
- Secure the adapter in the clamp using the "TIP stop" tech-
nique.
- Secure the key in the adapter using the "SHOULDER stop"
technique against the rotating plate on the adapter.
- Adjust the tracer vertically.
- You will need to lock the tracer in place (disable the spring
action system).
- Cut one side of the key after removing the rotating plate on
the adapter so as not to interfere with the cutter or tracer.
- Turn the two keys to the other side of the adaptor. Re-secu-
re the adapter in the clamp after turning it 180º.
- Finish cutting the second side of the key.
5.2.9 FO-6P key
See Figure 14
- Use this cutter-tracer set: F-22 / P-22.
- The key is secured in the clamp using the specific AD-FO
adapter.
- Position and secure the adapters on the clamp using the
"TIP stop" technique on the outside of the clamp.
- Make sure the key is properly flat when positioning the key
so that the cuts are distributed symmetrically across the key.
- You will need to lock the tracer in place (disable the spring
action system).
- Insert the tracer into the channel of a letter. Lock the head
height and raise the tracer slightly so it does not drag the
adapter.
- Cut the key.