Honeywell Vertex M User Manual page 83

Status indicators include:
IDLE - the analyzer is not monitoring or performing maintenance
l
MONT - the analyzer is monitoring
l
LD CC - Load Chemcassette™ routine is in progress
l
PROG - a new application program is being loaded into the analyzer
l
CONF - a new configuration is being loaded into the analyzer
l
COMF - a communications failure between the DAq and the analyzer
l
PYRO-W - a pyrolyzer analyzer is warming up. When pyrolyzer has reached stable
l
temperature, it will automatically go into monitor
FLOW - a flow Auto Balance procedure is in process on the analyzer
l
The Vertex M system displays only the short names of the location and target gases within each
point block. During normal monitoring, the background color of each block is white. Vertex M
will change the background color of a point as conditions change.
White
Blue
Grey
Red
Purple
Black
Alarm Indicators
When the target gas concentration for a point reaches a preset alarm level, Vertex M will display
a W, 1 or 2 in the point block to indicate the severity of the alarm.
Alarm Indicator
W (if enabled)
1
2
See "Configure Point" on page 60 for information on setting Alarm Level 1 and Alarm Level 2.
See "Other Menu" on page 72 for information on alarm default values.
Vertex M
Alarms for the point are disabled in the runtime options menu.
Point is disabled in the runtime menu or is disabled due to a fault.
Gas concentration exceeded an alarm level.
Disable configuration alarm.
Point is not configured for monitoring.
Lower Detectable Limit (LDL)
Alarm Level 1
Alarm Level 2
Normal operation.
Table 5-1
Concentration Threshold
83 User Manual