For more information see Allen-Bradley publication 1746-2.35. This can be found at:
http://literature. rockwellautomation.com/idc/groups/literature/ documents/td/1746-td006_-
en-p.pdf.
8.5.3 Default Relay Assignments
Note: User is required to setup the relay configuration. The default settings do not include any
faults or alarm levels.
Introduction
By default, the Vertex M reserves the first 2 contacts for faults. Any remaining relay contacts
may be associated with points in any analyzer. See "Set Analyzer Window" on page 59 for
procedures to associate relay contacts with alarms.
Main PLC
Vertex M
183
User Manual