Maintenance - Nautilus R614 Service Manual

FCC Compliance
!
the user's authority to operate the equipment.
The machine and power supply comply with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This machine and power supply have been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.

Maintenance

Read all maintenance instructions fully before you start any repair work. In some conditions, an assistant is required to do
the necessary tasks.
regular maintenance is done. Worn or damaged components must be repaired or replaced immediately.
Only manufacturer supplied components can be used to maintain and repair the equipment.
If at any time the Warning labels become loose, unreadable or dislodged, replace the labels. If purchased
in US/Canada, contact Customer Service for replacement labels. If purchased outside US/Canada, contact
your local distributor for them.
Daily:
After each workout, use a damp cloth to wipe your machine and Console free of moisture.
Note:
NOTICE: If necessary, only use a mild dish soap with a soft cloth to clean the Console. Do not clean
Weekly:
Clean the machine to remove any dust, dirt, or grime from the surfaces. Check for smooth seat
slider operation. If needed, apply a very thin coating of silicone lube to ease operation.
Note: Do not use petroleum based products.
Monthly
Check pedals and crank arms and tighten as necessary. Make sure all bolts and screws are tight.
or after 20 hours:
Tighten as necessary.
with a petroleum based solvent, automotive cleaner, or any product that contains ammonia.
Do not clean the Console in direct sunlight or at high temperatures. Be sure to keep the
Console free of moisture.
Silicone lubricant is not intended for human consumption. Keep out of reach of
children. Store in a safe place.
4