Table of Contents
Advertisement
Disconnect all power to the machine before you service it.
Note: Your machine may not match the image. For reference only.
To remove the Main Shrouds, start at Step 1. To remove only the Rear
Shrouds, go to Step 11.
1.
1-Piece Crank:
Go to Step 5.
2.
Using a wrench and socket, remove the Hex Head Bolt (C).
3.
Thread the Crank Puller into the Crank Arm (B). When the Crank Puller is
in the correct position, only 1-2 threads on the outer portion (CP2) of the Crank
Puller should show.
Note:
the Nut (CP2) as shown, before use.
4.
Using a wrench, turn the inner portion (CP3) of the Crank Puller clockwise.
The Crank Arm (C) will slide off as it is tightened.
Go to Step 7.
-
3-Piece Crank:
the Crank Arm (B) to expose the Hex Head Bolt (C). Continue to
Step 2.
C
B
CP1
CP2
34
B
CP3
Advertisement
Table of Contents
