Lock Led Indications - Assa Abloy Sargent Aperio IN100 Installation Instructions Manual

IN100 Mortise Lock

Lock LED indications

The lock has three LEDs. They support an optical scheme of red, yellow and green.
The indication scheme is described by the figures below:
Figure 4. Lock normal operation LED
indication
Card + PIN access
(configurable)
Access granted,
EAC offline or online
Access denied,
Force closed in remote
open/office mode
Busy blink, com hub
busy with other locks
Access denied,
Lock mechanism is
blocked when closing
maintenance required
Time to replace
Battery reached end
of life, lock disabled
V3 USB cable detection
action occurred
1) When the lock mechanism is blocked (lock jammed) the lever must be turned to
Some special LED indication schemes are used during lock maintenance actions:
Figure 5. Lock hub normal
operation LED indication
EAC response
time
Card access
(configurable)
EAC online
EAC offline
1)
Error in lock,
Tamper
the battery
release the lock mechanism.
Enter configuration
mode
Enter PIN
One yellow flash after card, two
flashes before PIN (.125 second)
One yellow flash (.25 second)
One green flash
(1 sec.)
One red flash
(1 sec.)
Five yellow flashes and
one red flash (.25 second)
Continuous yellow flashes
(.25 seconds every second)
Three red flashes
(.5 second each)
Continuous red flashes
(.125 seconds every 1 sec.)
Ten red flashes (.125 sec. each)
(Repeated every 10 sec. if lock can't close)
Ten red flashes (.125 sec. each)
repeated every 10 sec.
Continuous yellow flashes
(.25 seconds every 5 sec.)
Continuous red flashes (.25
seconds every 5 sec.)
Five yellow flashes
(.25 second each)
Five yellow flashes
(.125 second each)
1-800-810-WIRE • www.sargentlock.com • A8190B 21