Table of Contents
Advertisement
Note
15.4
CLEANING THE PUMP HEAD
When changing flexible tube or other parts, inspect all parts for dirt before assembling the pump head and clean
them if necessary.
We recommend cleaning the parts with a dry cloth. Solvent should not be used, because it can damage the plastics
and synthetic rubber parts. Use oil-free compressed air to clean the parts if available.
REPAIR INFORMATION
16
Note
PROPER DISPOSAL OF THE DEVICE
17
At the end of the life cycle of our products, it is important to take care of the appropriate disposal of obsolete
electrical and non-electrical devices. To help protect our environment, please follow the rules and regulations of
your country regarding recycling and waste management.
www.mc-techgroup.com
While mounting, make sure that the center of rotation and the roll carrier (driver) are
aligned.
Make sure that the collar of the shaft bore (see Figure 10) faces towards the front of the
pump head while mounting the roll carrier.
Use genuine spare parts only!
Aggressive condensate possible!
Media residues in tubing!
Chemical burns caused by aggressive media possible!
Wear protective gloves and protective glasses!
Wear proper protective clothing!
When sending the peristaltic pump to M&C customer service for repair, please indicate
the type of medium pumped. Before shipping the pump, please remove hazardous or
aggressive contaminations from all parts of the pump!
SR25 | 1.01.01
21
Advertisement
Table of Contents
