Changing Contact Pulleys And Springs; Figure 9 Different Pump Tube Sizes; Figure 10 Disassembly Of Pump Head And Driver - M&C SR Series Instruction Manual

Figure 9 Different pump tube sizes
15.2

CHANGING CONTACT PULLEYS AND SPRINGS

Note
Follow these instructions to change the contact pulley and springs:
1. Disconnect the peristaltic pump from power supply
2. Unscrew nuts of the pump head (wrench size 5.5)
1 Pump head nuts
Groove
4

Figure 10 Disassembly of pump head and driver

3. Remove the pump head
4. Now the driver can be removed from the pump head and is ready for maintenance.
5. The removal of the springs 4 pcs.)
this take spring out of the groove
www.mc-techgroup.com
While mounting, make sure that the center of rotation and the driver are aligned.
Use genuine spare parts only!
2 Pump head
Driver (roll carrier)
5

from the motor shaft

away from the driver is easily possible without the aid of any tools. For

near to the shaft bore.

3 Springs
Collar of the shaft bore
6
SR25 | 1.01.01 19