Table of Contents
Advertisement
DIRECTIONS FOR USE
ARM REST INSTALLATION AND ADJUSTMENT INSTRUCTIONS
OPTIONAL ACCESSORY
AVAILABLE ON 4 SECTION TOP ONLY
CAUTION: Do not use the arm rest
for customer weight support during the
mounting or dismounting of the table.
The arm rest is not designed to support
the patient's weight.
TO INSTALL THE ARM REST:
The arm rests adjust automatically as the table's back support moves to remain parallel to the floor in any position.
They are designed to be strong and will take a reasonable amount of weight, but they are not designed to be used to
sustain a person's weight when getting on or off the table.
1. Insert end of arm rest into
hole in backrest while holding
arm rest at 60° angle.
To remove the arm rest, simply reverse the procedure above.
TO LEVEL THE ARM REST:
The arm rest height is adjusted to level at the factory. When in use, some of the new
parts will wear, and you may see some sagging of the arm rest over time. If the arm
rest is too low the height can easily be adjusted using the enclosed Allen wrench.
To Raise the Arm Rest
1. Loosen bottom 2 set screws
(turn counter-clockwise).
13
Adjustable Side Arm Rests
2. Push end all the way into hole and drop arm rest into horizontal
position. Tug slightly to make sure the armrest is fully locked to
the table (for patient safety).
2. Turn side set screw (clockwise
to raise or counter clockwise to
lower) while lightly raising the
arm rest with your other hand
(to make the adjustment easier).
Manicure Arm Rests
3. When you have achieved the
desired height, tighten the two
bottom set screws (turn clockwise).
Advertisement
Table of Contents
