Adjustable Side Arm Rest (Accessory Option) - OAKWORKS PF Series User Manual

DIRECTIONS FOR USE
ADJUSTABLE SIDE ARM RESTS (ACCESSORY OPTION - PF400 ONLY)
CAUTION
TO INSTALL THE ARM RESTS:
The Arm Rests adjust automatically as the back rest moves to remain parallel to the floor.
1. Insert end of arm rest into
backrest hole while holding
the arm rest at a 60° angle
to the backrest.
TO LEVEL THE ARM RESTS:
The Arm Rest height is adjusted at the factory for each table. If the armrest starts to sag with repeated
use, follow the steps below to readjust.
1. Loosen the bottom 2 set
screws.
• Do not use the arm rest for client support during the mounting or dismounting of the
chair.
• The arm rest is not designed to support the client's weight.
2. Push end all the way into the hole and drop the arm rest into the
horizontal position. Pull outward to make sure the arm rest is
secure.
2. Turn the side set screw
(clockwise to raise or
counter-clockwise to
lower) while adjusting the
arm rest. Lift the arm rest
slightly when doing this
adjustment to reduce the
weight.
3. Tighten the two bottom set
screws to lock the position.
16