Table of Contents
Advertisement
Contents
14.3 On the underside of the head, remove three screws
14.4 Operate the pan brake lever
14.5 If brake pressure is not felt after approximately one-third of the lever travel, turn the locating pin
(5)
clockwise until this is achieved.
14.6 Operate the pan brake lever
14.7 Refit cover plate
Repositioning the wedge adaptor
15
The wedge adaptor is secured by four cap head screws which pass through the wedge adaptor into the
sliding plate.
WARNING!: Over-long screws will prevent the sliding plate from operating. Always use
the screws provided (M6 x 30mm).
16
To reposition the wedge adaptor
16.1 Engage the centre lock
(4)
(3)
(7)
from the OFF to the ON position.
(7)
to the OFF position and ensure that the head is free to rotate.
(3)
and secure with three screws (4).
(Fig
4.5):
(3)
and remove the load.
Fig 4.5 Repositioning the wedge adaptor
First
Previous
Page
Page
(4)
securing cover plate (3).
Next
Previous
Page
View
(1)
(2)
V70RIGHT
25
Advertisement
Table of Contents
