Table of Contents
Advertisement
Contents
Tilt unit cover and balance knob
30
Install tilt unit cover and balance knob as follows
30.1 Install 'O' ring (20) in the tilt unit cover (33).
30.2 Install the tilt cover/centre lock assembly (30-37) on the tilt back plate (41), ensuring dowel (31)
engages in appropriate slot. Secure assembly with three screws (10).
30.3 Install washer (21) and spring (22) on shaft (23) and secure with pin (24).
30.4 Centralize pin (24) and install drag knob boss (25).
30.5 Install the balance knob (26) and secure with washer (27) and screw (28).
30.6 Install knob bung (29).
Platform assembly
31
To assemble the platform, proceed as follows
31.1 Slide the rack strip (28) into the slide plate (1) and secure with three Spirol pins (29).
31.2 Install two serrated discs (4) on the platform (27) and secure each with three screws (2) and
three spirol pins (3).
31.3 Affix the self-adhesive PTFE strip (10) to the platform.
31.4 Secure the front stop bung (8) (Vector 700H only) to the platform using Permabond ESP 110,
ensuring flat face faces forwards
31.5 Secure the platform buffer (9) to the platform (or front stop bung (8)) using Loctite 415, ensuring
flat face faces forwards.
31.6 Lubricate the adjustment shaft assy worm (6), platform adjustment pinion (11) and both bearings
on adjustment shaft assy shaft (6) with LM grease.
31.7 Install platform adjustment pinion (11) in bearing bracket (12). Fit bearing bracket to adjustment
shaft assy (6) and position on platform. Secure bracket lightly with two screws (13).
31.8 Install shaft support (16) on adjustment shaft assy (6) and secure lightly to platform with two
screws (17). Position shaft support to remove end float on adjustment shaft assy and tighten two
screws (17).
31.9 Install platform adjustment knob (14) and secure with screw (15). Turn knob and ensure
mechanism operates freely. Remove screw (15) and knob (14) and fully tighten two screws (13).
Replace knob (14) and secure with screw (15) using Loctite 222E.
31.10 Affix the self-adhesive platform adjustment cover (5) to the platform.
31.11 Install two brake disc Spirol pins (3) in platform (27), so that pins protrude 5 mm
31.12 Pass two screws (21) through tilt brake centre (20) and brake disc (tilt) assembly (19). Install on
Spirol pins (3) and secure with two screws (21).
First
Page
(Fig
6.10):
(Fig
6.11):
Previous
Next
Previous
Page
Page
View
47
Advertisement
Table of Contents
