Selecting A Test - Racelogic Motorsport VBOX Touch V2 User Manual

Selecting a Test

You can access the Decel Mode settings screen by selecting the
Decel Mode. This is where you choose the test parameters and see other test options.
uch_(v2%2F%2Fv3)/User_Guide_%E2%80%93_VBOX_Touch_(v2%2F%2Fv3)/05_Display_Modes_%E2%80%93_VBOX_Touch_(v2%2F%2Fv3)/Decel_Mode_-
• Time taken
• Average deceleration achieved
• Maximum deceleration achieved (g)
• Height difference
These values will start to populate when the start
condition of the test is met. When the end condition is
met, they will remain on screen until the start condition is
met again. You can reset a test by pressing the
button at the bottom of the screen.
Trigger decel test: When you have selected this test
type you will see the following data:
• Distance travelled
• Run number
• Trigger time
• Trigger speed
• Corrected distance
• MFDD
• Average deceleration
These values will start to populate when the minimum
trigger speed is met and the trigger is activated. When
the vehicle is stationary (below 2.5 km/h), the data will
remain on screen until the minimum trigger speed is met
and the trigger is activated again. You can reset a test
by pressing the Reset button at the bottom of the
screen.
When the trigger is activated, you will see 'ON' displayed
next to the Trigger test header.
Settings button at the bottom left of the screen in
https://en.racelogic.support//Product_Info/Performance_Meters/VBOX_Touch/
Reset
_VBOX_Touch_(v2%2F%2Fv3)
38