Table of Contents
Advertisement
Installation and operating manual
2.5.5 Installation
The improper assembly or electrical installation of the product and accessories may result in personal injury
and damage to property and impair operation.
For safe assembly and electrical installation, observe the following:
•
Assemble the product and all the parts, accessories and materials used free of mechanical stress.
•
Check all plug connections are correctly fitted.
•
Prevent trip hazards by routing hoses appropriately.
•
Fasten and fix all hoses in such a way that they cannot make any percussive movements.
•
Install the inlet and drain lines for condensate as fixed pipes.
2.5.6 Maintenance
Improperly carrying out maintenance and repair work may result in serious injury or death.
For safe maintenance and repairs, observe the following:
•
Before starting work, bleed the pressurized product and accessories and lock them out so that they
cannot be pressurized by accident.
•
Before starting work, cut off the condensate feed to the product and divert the incoming condensate into
a separate container.
•
Only use materials approved for the respective application.
•
Use only suitable tools in perfect condition.
•
Only use cleaned pipes and hoses that are free of dirt and corrosion.
•
Do not use abrasive or aggressive cleaning agents or solvents that could damage the external coating (e.g.
labels, type plate, corrosion protection, etc.).
•
Do not clean or operate the device with hard or pointed implements.
•
Make sure to only use the specified materials and fluids for cleaning.
•
Comply with all applicable hygiene regulations and regional and internal hygiene rules and standards.
•
Ensure order and cleanliness during maintenance and repair work. Prevent impurities from penetrating
into the opened product or accessories. Store dismantled components and accessories directly in a safe
place.
•
After completing maintenance and repair work, remove all tools and cleaning agents used, as well as all
parts that are no longer needed, from the work area.
•
Only dispose of the product and accessories once they have been cleaned and are free of any residual
fluids.
•
All components, assemblies, operating, auxiliary materials and cleaning agents must be disposed of
appropriately and according to regional statutory specifications and provisions.
•
Dispose of electrical and electronic components through a specialized disposal company or return them
to the manufacturer.
QWIK-PURE
CS
®
11 | 64
Advertisement
Table of Contents
Need help?
Do you have a question about the QWIK-PURE CS 400 and is the answer not in the manual?
Questions and answers