Table of Contents
Advertisement
Command
IP Configuration (continued)
NOTES:
•
Changes made to any TCP/IP settings do not take effect until the reboot network command (
•
IP address setup commands that are followed by
Administrator status result in an
Ethernet Port Configuration
Set web port map
Reset web port map
Disable web port
View web port mapping
Set Telnet port map
NOTE:
Telnet port 23 is disabled by default.
Reset Telnet port map
Disable Telnet port
View Telnet port mapping
SIS‑over‑SSH
NOTES:
•
The echo setting must match the type of SSH client used.
window are echoed in the window along with the SIS response, and are also sent to the server.
•
With echo disabled, the characters are not echoed but are simply sent to the server.
•
The echo setting applies only to current (not global) connection.
•
Control systems should turn echo off after connecting.
Enable echo (default)
Disable echo
View echo status
Set SIS-over-SSH port map
Reset SIS-over-SSH port map
Disable SIS-over-SSH port
View the SIS-over-SSH port
mapping
KEY:
X#
=
Echo status
X3&
=
Network interface card (NIC) number
ASCII Command
Host to Switcher
24
require Administrator permission to enter. Attempts to issue them without
E24
(privilege violation) error message.
E
W {port number}
}
PMAP
E
}
W 80 PMAP
E
}
W 0 PMAP
E
}
W PMAP
E
Z {port number}
}
PMAP
E
}
Z 23 PMAP
E
}
Z 0 PMAP
E
}
Z PMAP
E
}
1ECHO
E
}
0ECHO
E
}
ECHO
E
X3&
B
*{port number} PMAP
E
X3&
}
B
*22023 PMAP
E
X3&
}
B
*0 PMAP
E
X3&
}
B
PMAP
0 = Off or disabled, 1 = On or enabled (default)
1-3
Response
Switcher to Host
]
Pmap W{port number}
]
Pmap W 00080
]
Pmap W 00000
]
{port number}
]
Pmap Z{port number}
]
Pmap Z 00023
]
Pmap Z 00000
]
{port number}
With echo enabled (default), characters that are typed into the client
]
Echo 1
]
Echo0
X#]
}
X3&
PmapB•
*{port number}
X3&
]
PmapB•
*22023
X3&
]
PmapB•
*00000
]
{port number}
UCS 303 • SIS Communication and Control
Additional Description
E
}
2BOOT
) is issued.
Set the web port number.
Set the web port number to 80
(default).
Disable the web port.
View the currently set web port.
Set the Telnet port number.
Set the Telnet port number to 23
(default).
Disable the Telnet port.
View the current Telnet port.
Echo on: All data sent is echoed
back to the sender, followed
by the response. Extra carriage
returns may also be received
when echo is on.
Echo off: only the response is
sent to the sender.
View the echo setting
]
Set the SIS-over-SSH port
Reset the SSH port to the
default 22023.
Disable the SIS-over-SSH port.
View the current SIS-over-SSH
port mapping.
35
Advertisement
Table of Contents
