Pre-Installation Notes - Schlage BE468 Manual

PRE INSTALLATION
NOTES
The deadbolt included is preconfigured to fit a
standard door frame.
Note your 6 digit programming code located on a sticker on
inside of your lock (alarm assembly) before you begin
installation. This may be needed for panel pairing if this unit
was not purchased as a part of your primary system order.
When tightening any screws, be sure to make sure that
no parts move by hand once tightened.
Be sure not to over tighten any screws. This can
prevent the deadbolt from moving freely.
Additional installation instructions can be found at:
https://youtu.be/ZVyzexUnHeA