Advertisement
Installation
1
Prepare door.
Use the included door template to complete the door
preparation.
Do not drill through the backplate. The drill can catch on the
backplate and cause injury.
2
Install DPS (door position switch), if desired.
2a Prepare a 3/ 4" (19 mm) hole, 1 1/2" (38 mm) deep in the jamb
exactly opposite the prepared hole in the door edge.
2b Install the jamb side of the switch into the hole.
Magnet with no wire.
2c Route the cable through the hole in the door edge and then
through the hole on the inside of the door. Then push the
switch into the hole.
3
Install strike.
BAG 1
CAUTION
Route through hole
marked on template.
Actual Size
4
Install chassis.
Check lock handing before installation.
4a To change handing, if necessary, pull latch out and rotate 180° .
Deadbolt
model shown
Pull out the latch
and rotate 180° .
4b Insert chassis into mortise and secure with screws.
BAG 1
4c Install cover plate.
BAG 1
2
NOTICE
Advertisement
