Ferno ScoopEXL User And Maintenance Manual page 22

31A
Figure 31 - Restraint application with "marlinspike hitch"
TWO-PIECE RESTRAINTS WITH
PLASTIC BUCKLE
INTRA-HOSPITAL USE (CODE: 430-PA-2-N)
For intra-hospital use of the ScoopEXL stretcher, 430-PA-
2-N restraints can be applied in a transverse configuration as
shown in Figure 32.
1. Place the first restraint in the underarm position,
hooking it into holes 9 and 2.
2. Apply the second restraint at waist level, hooking
it into holes 8 and 3 or 7 and 4, depending on the
patient's height.
3. Apply the third restraint transversely across the
patient's shins, hooking it into holes 6 and 5.
Figure 32 - Configuration of 430-PA-2-N restraints
for intra-hospital use
22
"SPIDER" 770-E RESTRAINT SYSTEM
1. Open the 770-E restraint if it is rolled up on itself.
2. Adjust the length of the restraint according to the
patient's height. To adjust the length, please refer to
the 770-E restraint manual.
3. When the patient is on the stretcher, place the restraint
31B
system on it.
4. Pass each flap of the restraint through the respective
handle of the scoop, passing it from the inside and
closing it by turning it around the handle, matching
the two Velcro straps (Figure 33).
5. Before performing any operation with the stretcher,
check that all restraints are correctly and securely
locked and that they are in good condition.
ScoopEXL stretcher
(CODE: 770-E)
Figure 33 - 770-E restraint system
© Ferno S.R.L. ScoopEXL - Rel.31102023 - ENG