Material Selection; Machine Adjustments; Wheel Replacement - Baileigh Industrial EW-21 Operator's Manual

MATERIAL SELECTION

CAUTION:
processed through the machine are NOT potentially hazardous to operator or
personnel working nearby.
When selecting materials keep these instructions in mind:
• Material must be clean and dry. (without oil)
• Material should have a smooth surface so it processes easily.
• Dimensional properties of material must be consistent and not exceed the machine capacity
values.
• Chemical structure of material must be consistent.
• Buy certificated steel from the same vendor when possible.

MACHINE ADJUSTMENTS

Wheel Replacement

Important: Hold an upper wheel securely when installing or removing it or it may
fall causing injury or damage! Wear steel toe foot-wear to protect your feet.
Upper Wheel Replacement
1. Raise the lower wheel until the top lightly touches the bottom of the upper wheel. This help to
supply some support to the upper wheel.
2. Remove the cotter pin from the inside of the upper wheel axle.
3. Hold the upper wheel firmly to prevent dropping and remove the upper wheel axle.
4. Carefully remove the upper wheel and set it on the upper wheel rack using a bracket
mounting shaft.
5. Place a different upper wheel into the upper wheel bracket.
Note: Adjust the lower wheel height as needed to allow the upper wheel to fit into
the upper wheel bracket.
6. Align the bracket and wheel bearing holes, insert the axle, and rotate the latch to secure the
wheel.
It must be determined by the customer that materials being
15
15