Operation Procedures - Marantz PM-82 User Manual

BASS AND TREBLE TONE CONTROLS
Adjusts the tone by controlling the levels of two frequency bands. Turn
each control toward (+) to enhance the corresponding frequency
band, or toward (—) to attenuate it.
TREBLE: Adjusts the high frequency level.
BASS: Adjusts the low frequency level.
@) CLASS A SWITCH
Switches the amplifier operation mode between Class A
(25 W, 8-ohm) and Class AB (100 W, 8-ohm).
The CLASS A indicator lights when the Class A operation is set.
This switch must be pressed while the power is OFF.
The initial setting of this switch is for Class AB operation.
NOTE:
The temperature of the top cover of the unit may rise during Class A
operation, but this is not a malfunction. Do not place any object on the
unit for this may block the ventilation and cause damage or malfunction.
SPEAKERS 1/2 SWITCHES
These switches are used to select the speaker system(s) connected to
the SPEAKER SYSTEM 1/2 terminals on the rear panel. If both the 1
and 2 switches are pressed to the low positions, two speaker systems
can be used at the same time.
When headphones are used for listening, set both switches 1 and 2 to
OFF (high positions).
PHONES JACK
Insert the standard phone plug of the headphones into this jack.
OPERATION PROCEDURES
2 Operate each equipment to start play.
TO PLAY AN ANALOG RECORD
1. Set the INPUT SELECTOR switch to PHONO.
Press the MM/MC switch on the rear panel according to the type of
cartridge (MM or MC) used on the turntable.
2. Play a record on the turntable.
3. Adjust the volume with the VOLUME control and adjust the tone
with the BASS and TREBLE controls.
NOTES:
@ Set the VOLUME control to the minimum position before placing
the stylus on the record or before replacing the cartridge.
@ Do not apply shock or vibration to the turntable during play, as this
may cause the stylus to jump and the analog record to be damaged.
@ |fthe turntable is installed too close to the speakers, the volume may
not be able to be increased to a high level due to howling.
@ Do not switch the power OFF while the stylus is on the record
surface.
TO LISTEN TO FM/AM BROADCASTS
1. Set the INPUT SELECTOR switch to TUNER.
2. Tune in the desired station on the tuner.
3. Adjust the volume with the VOLUME control and adjust the tone
with the BASS and TREBLE controls.
TO PLAY A COMPACT DISC
1. Set the INPUT SELECTOR switch to CD.
2. Play a CD on the CD player.
3. Adjust the volume with the VOLUME contro! and adjust the tone
with the BASS and TREBLE controls.
TO PLAY A COMPONENT CONNECTED
TO AUX 1/2 JACKS
The component connected to the AUX 1 or AUX 2 jacks on the rear
panel can be played as follows.
1. Set the INPUT SELECTOR switch to AUX 1 or AUX 2.
2. Play the component connected to the selected input.
3. Adjust the volume with the VOLUME control and adjust the tone
with the BASS and TREBLE controls.