Tape Deck Operation - Marantz PM-82 User Manual

TAPE DECK OPERATION
Controls used for operating the tape deck.
TAPE PLAYBACK
1. Press the TAPE 1 monitor switch @). The indicator above the switch
lights up.
2. Play a prerecorded tape on the tape deck.
3. Adjust the volume with the VOLUME control @).
4. Adjust the tone with the BASS and TREBLE controls ©).
NOTES:
@ When not playing tapes, press the MONITOR switch again (so that
the SOURCE indicator lights).
@ The tape can be played regardless of the setting of the INPUT
SELECTOR ©.
TAPE RECORDING
The playback sound of a program source component, such as a
turntable, a tuner, or a CD player, can be recorded on tape as follows.
1. Set the INPUT SELECTOR switch © to the program source to be
recorded.
2. Play the program source.
3. Operate the tape deck(s) to record the playback sound on tape(s).
TAPE MONITORING
When a three-head tape deck is connected to the TAPE 1 jacks, the
sound recorded on tape can be monitored through the speakers by
pressing the TAPE 1 monitor switch @). In this case, the tape deck
must be connected to this unit via both recording and playback
connection cords.
NOTE:
When the tape deck is a two-head system, the recorded sound cannot
be monitored even when the TAPE 1 monitor switch @) is pressed. In
this case, however, the sound of the program source being recorded
can be monitored.
REC SELECTOR
Use when copying tapes or recording a music source such as a CD.
1. When set to OFF, no signal is output from the REC OUT jacks.
Except when recording a tape, there is no need to output a signal
from the REC OUT jacks. By setting this switch to OFF, you can
shorten the signal path within the unit to minimize sound degrading
factors such as crosstalk.
2. When set to SOURCE, the signal selected by the INPUT SELEC-
TOR © can be recorded onto a tape.
3. When set to CD, a CD can be recorded directly from the CD player
regardless of the position of the INPUT SELECTOR ©.
4. The TAPE COPY positions allow you to copy tapes from TAPE 1 to
TAPE 2/3 or from TAPE 2 to TAPE 1/3.
To monitor the sound being recorded, press the TAPE MONITOR
switch @).
When recording at the TAPE COPY or CD positiion, you can listen
to another source selected with the INPUT SELECTOR ©).