Basic Operation - Marantz SC-11S1 User Manual

_ .c:M
IIIEl'UI
I I
lC.OI£IIU _ _
I I I
]
"'""'
.....
©
a
c::::::J
©
J
0)
f:
0
~
0
• Disc Playback on a Super Audio CD
Player
1. Press the power ON/OFF switch of the Super Audio CD
player to activate power to it.
2. Press the power ON/OFF switch
CD
on the unit to activate
power to it. When using multiple amplifiers connected by
F.C.B.S., turn the power ON in the order of lowest to highest
ID number.
3. Select the input source from the INPUT SELECTOR knob
@ on the unit, or the INPUT SELECT buttons
OJ
of the
remote controller.
4. Press the PRE OUT
®
button to switch output from the
unit ON.
5. Turn on the power to the connected power amp.
6. Load a disc into the Super Audio CD player and press the
PLAY button to start playback.
7. Adjust the volume level using the VOLUME knob
®
on
the unit or the VOLUME
~T
buttons [§] on the remote
controller.
8. You can turn the display and side illumination ON/OFF as
suited for the room environment. Press the DISPLAY button
®
on the unit or the DISPLAY button
[I]
on the remote
controller.
To explain how to play back input sources, typical examples
are given with disc playback from a Super Audio CD player
and record playback from an analog record player.
Refer to the connection procedures and check that each
component is correctly connected to the amplifier.
I (
BASIC OPERATION
( PLAYBACK
• Disc Playback on an Analog Record
Player
1. Press the power ON/OFF
CD
switch of the unit to activate
power to it. When using multiple amplifiers connected by
F.C.B.S., turn the power ON in the order of lowest to highest
ID number.
2. Select the PHONO using the INPUT SELECTOR knob
®
on the unit, or the INPUT SELECT buttons
OJ
of the
remote controller. To prevent unexpected accidents, it is
recommended to set the volume level to
-00
(mute) by
turning the VOLUME knob
®.
3. Set the PHONO MC button
®
to MM or MC according to
the cartridge you are using.
4. Press the PRE OUT
®
button to switch output from the
unit ON.
5. Turn on the power to the connected power amp.
6. Set a record on the analog record player and play it.
7. Adjust the volume level using the VOLUME knob
®
on
the unit or the VOLUME
A/T
buttons [§] on the remote
controller.
8. You can turn the display and side illumination ON/OFF as
suited for the room environment. Press the DISPLAY button
®
on the unit or the DISPLAY button
[I]
on the remote
controller.
Rlapanlz
20