Configure Io-Link Device Parameters Using The Add-On Profile - Allen-Bradley Rockwell Automation 1734-4IOL User Manual

Chapter 4 Configure the POINT I/O 4 Channel IO-Link Master as IO-Link Master Using the Studio 5000 Add-on Profile
Device Discovery Dialog
Parameter Description
Status 19.Device on IO-Link Master. IODD File in Catalog only.
There is a device connected to the master but no device configured for the channel in the project. The device has no IODD file but
(continued)
there is a file for the device registered in the device catalog on the workstation. You can choose to "use" this channel
configuration. Doing so configures the channel with the device that was discovered.
20.Channel mode is not IO-Link.
The channel is not configured for IO-Link mode. No information is displayed and you cannot "use" this channel configuration. The
word "False" appears where the checkbox in the "Use" column normally would.
Register IODD Selecting the checkbox in this column causes the master to upload the IODD file found in the device and register it
locally. The checkbox is disabled if there is no IODD file embedded in the device.
Use The rows in the Device Discovery dialog represent what is found connected to the device. You can choose to use what
is discovered by selecting the checkbox in this column. The checkboxes are selected by default. A row is automatically
selected if any sort of difference is found between what is configured on the device and what is configured (or not
configured) in the project.
Configure IO-Link Device
Parameters Using the
Add-on Profile
40
After you add an IO-Link device, you can configure device parameters for
IO-link devices with IODD Advanced integration level from the Add-on Profile.
Before you proceed with this task, take note that:
• Parameters vary depending on data provided in the IODD file of an
IO-Link device.
• You cannot change or read a Generic IO-Link device's parameters from the
Add-on Profile. See Configure IO-Link Device Parameters Using Message
Instructions on page 47
1. In the Channel tree, click the IO-Link device under the IO-Link channel.
The Common tab appears on the working pane.
Depending on the data provided in the IODD file, up to four more tabs
may be shown for the selected device: Identification, Observation,
Parameter, and Diagnosis.
for more information.
Rockwell Automation Publication 1734-UM020B-EN-E - August 2019