Generac Power Systems Power Zone Pro Sync Owner's Manual page 39

Alarm Display Text
GEN VOLTAGE CA NOT SETUP
GEN APPARENT PWR LL TOTAL NOT SETUP
GEN REACTIVE PWR LL TOTAL NOT
SETUP
GOVERNOR THROTTLE POSITION 1
NOT SETUP
ESTOP 1 NOT SETUP
J1939 NO MIC3 COMMS
J1939 NO VARISTEP COMMS
SHUTDOWN BYPASS IS ACTIVE
SHUTDOWN ALARM IS BYPASSED
BASELOAD SWITCH STILL OPEN
BASELOAD COMMS LOSS
NO DUAL FUEL SENSOR SELECTED
PLC PROGRAM x OUTPUT INVALID
PLC ESTOP
PLC PROGRAM x DOF ALREADY USED
INCOMPATIBLE PWM5 CONFIG IN USE BY AVR
INCOMPATIBLE PWM6 CONFIG IN USE BY AVR
INVALID DI CONFIGURATION FOR SHUTDOWN
BYPASS
Owner's Manual for Power Zone Pro Sync
Type Alarm Description
SD See AI, AO, DI and DO XXX NOT SETUP
Alarms.
SD See AI, AO, DI and DO XXX NOT SETUP
Alarms.
SD See AI, AO, DI and DO XXX NOT SETUP
Alarms.
SD See AI, AO, DI and DO XXX NOT SETUP
Alarms.
SD See AI, AO, DI and DO XXX NOT SETUP
Alarms.
SD Lost J1939 CAN bus communications with
MotorTech MIC3+ Ignition Module
SD Lost J1939 CAN bus communications with
MotorTech Throttle Module
WN Generator protection system is mostly disabled
to provide critical support
WN Shutdown condition has occurred while
generator protection system is mostly disabled to
provide critical support
WN Transfer switch open during a baseload
operation
WN No Baseload communications within designated
time
SD Dual Fuel selected, but no Fuel Pressure Sensor
is setup
SD PLC program using invalid output. Can be for
PLC program numbered 1-8.
SD PLC program used ESTOP output
AL Duplicate DOFs used in multiple PLC programs.
Can be for PLC program numbered 1-8.
SD Shutdown condition has occurred as AVR
Excitation Control Output #1 has been configured
by the user as something else
SD Shutdown condition has occurred as AVR
Excitation Control Output #2 has been configured
by the user as something else
WN Warning condition has occurred as Activate
Shutdown Bypass digital input is not configured
or configured incorrectly
Troubleshooting
35